This manual details the steps to set up the LinkedGo Smart underfloor-heating thermostat with the Shelly Pro 1 relay, allowing the thermostat to switch the boiler on and off based on the desired room temperature.

LinkedGo Smart floor heating thermostat

Step-by-Step Setup

Step 1: Log In / Master Card

Tap the Master card (or go to the main settings of the app/system).

Step 2: Access the Thermostat Settings

Select the "Thermostat" option in the main menu.

Step 3: Add a New Thermostat

1. Tap the "+" symbol to start adding a new thermostat.

2. Then tap the "Next" option.

Step 4: Defining the Thermostat Type and Output

1. Select the Thermostat Type: Heating/Cooling.

2. Select the Output Type that matches your setup (e.g. Relay, dry contact, etc.).

Step 5: Selecting the Actuator (Control Relay)

Select the actuator that will switch the boiler on. In this case, choose the Shelly Pro 1 device.

Step 6: Selecting the Temperature Sensor

Select the sensor that will provide the room-temperature reading. In this case, choose the LinkedGo Smart floor heating thermostat device.

Step 7: Save and Name

Save the configuration with a descriptive name (e.g. "Living Room Heating", "Main Boiler").

How it works:

Once the setup is complete, when you adjust the temperature on your LinkedGo Smart floor heating thermostat, the system will automatically switch the Shelly Pro 1 (and therefore the boiler) on or off to maintain the set temperature.