This manual details the steps to configure the LinkedGo Smart underfloor heating thermostat with the Shelly Pro 1 relay, allowing the thermostat to turn the boiler on and off based on the desired room temperature.

LinkedGo Smart floor heating thermostat

Step-by-Step Setup

Step 1: Login / Master Card

Press the Master card (or access the main application/system settings).

Step 2: Accessing Thermostat Settings

Select the "Thermostat" option in the main menu.

Step 3: Add New Thermostat

1. Press the "+" symbol to begin adding a new thermostat.

2. Next, press the "Next" option .

Step 4: Defining the Thermostat Type and Output

1. Select the Thermostat Type: Heating/Cooling .

2. Select the Output Type that matches your configuration (e.g., Relay, dry contact, etc.).

Step 5: Actuator Selection (Control Relay)

Select the actuator that will activate the boiler. In this case, choose the Shelly Pro 1 device .

Step 6: Temperature Sensor Selection

Select the sensor that will provide the ambient temperature reading. In this case, choose the LinkedGo Smart floor heating thermostat .

Step 7: Save and Name

Save the settings with a descriptive name (e.g., "Living Room Heating", "Main Boiler").

Operation:

Once the setup is complete, when you adjust the temperature on your LinkedGo Smart floor heating thermostat , the system will automatically turn the Shelly Pro 1 (and therefore the boiler) on or off to maintain the set temperature.